Buck Mask Blank

Remember, just because the resin blank says it's one thing, doesn't mean it can't be altered to look like something else! This can be done by adding a little bit of foam to certain areas, and you can change the entire look of the mask, not just for the species, but also for the expression.

• Fox turned into a sugar glider
• Fox turned into a raccoon
• Large K9 turned into a boar

You can also turn our semi-realistic resin bases into full toony heads if you like. Just cut out the entire eye area and add your own large toony eyes, like these:

• Bunny mask turned toony
• Adding toony eyes to a small k9
• Giving a fox toony eyes

HINGES: We do sell hinges separately should you choose to order an uncut blank. They come in either a V-hinge shape, a hybrid hinge or a straight hinge shape. We send all of our cut and hinged heads with a hybrid hinge, however most can be straight hinged unless your face is a little larger, in which case the hybrid or V hinge option is better. The V hinge/Hybrid system is also said to have more sensitive jaw movement in comparison to the straight hinge. Please pay attention to the description of each mask, to see which hinge system works!

Type of masks: Our masks come uncut, cut, or cut and hinged. We do not set up the moving jaw; it is the customers responsibility to make their moving jaw in the best way for them. You can either use the elastic method or the spring method; whichever you find to be easiest for you.

• Uncut masks are straight pulled from the mold and sanded around the edges so they aren't sharp, and shipped to the customer as such. The customer then has to cut and hinge it themselves.
• Cut masks are pulled from the mold and cut out, and then sanded around all sharp edges. The customer then has to hinge it themselves. These masks are prone to warping during transit however, since there is nothing holding the edges in place!
• Cut and hinged masks are pull from the mold and cut, sanded around all edges and then the hinges are installed. It is then sent to the customer ready to have everything installed. Springs are attached on the upper jaw, however you need to figure out the placement for where it goes on the bottom, as it tends to vary on a per person basis.

*our springs are made with a zinc plated music wire and are custom ordered as such so will never rust, nor need oiling. Positioning of the springs on a mask varies per person, since each person is typically shaped differently, and the spring needs to be positioned according to that and the specific tension they need*

If you're curious about how we do the padding inside our masks, please watch this video for examples

BUCK INFO

Fits up to a 24" head with padding on the inside. This head will fit glasses.

The nose on the resin blank is textured and sticks out far enough so it can be used for the final product; can be painted with any paint that works on plastic, but be sure to wash the blank off first with soap and water so it sticks.

Will fit our buck lower jaw, and deer tongue
Will fit 1.75"3D and 2"3D clear resin eyes. 2 inch 3D thin eyes are ideal.
Fits a 1" or 1.5" fan kit.
Fits all of our antlers except for the small whitetail, and the straight/curved 4 point.

The buck version has two platforms on the head to allow for easy attachment of antlers. Antlers can be attached in a variety of ways; magnets, screws, heavy duty glue, etc.

Works with a straight, V or hybrid hinge.